No-Drill Adhesive Mounts for Acrylic Neon Signs, Sets of 4 or 8

Not every wall can take a drill: a rental apartment, a tiled bathroom, a glass partition, a kid’s room you would rather keep free of holes. These are our own no-drill mounts for acrylic neon signs.

Each mount is a clear adhesive base plate with a round resin seat and a threaded stud. The stud goes through the hole in the sign’s board, and a cap screws on to hold it, without a single screw in the wall.

To put them up:

• clean the wall so it is smooth, dry and free of dust
• peel the release film off the back of each mount
• press each mount firmly onto the wall where a hole of the board will sit
• wait before hanging the sign, so the adhesive can bond
• fit the board over the studs and screw on the caps

Use one mount at each corner; four suit most signs. They fit the 1/4 in holes in our acrylic signs.

They hold best on smooth, sealed surfaces such as tile and glass. Textured walls and fresh paint hold less, so choose wall standoffs or a ceiling hanging kit there instead.

Every LED sign ordered with no-drill adhesive mounts already includes a set. Buy this one as a spare or an extra set: for a second sign, a new spot or a replacement.

A set of 4 covers a sign with a hole at each corner, which is most signs. Choose 8 for two signs, or for a wide sign with more holes.

Check the wall first. Tile, glass and other smooth, sealed surfaces are ideal. If the wall is textured or freshly painted, the mounts hold less; there, wall standoffs or a ceiling hanging kit are the better choice.